China Quality parts Professional Precision machining,Precision parts processingMotor shaft, Bushings, rivets, special screws, nuts, etc.Precision partsProcessing. Products are widely used in automotive, communications, medical, watch, mobile phone, computer and other industries.
What are the processing requirements for precision parts? For Precision parts, the processing is very strict, and the processing procedures include cutting in and cutting out. There are specific requirements for size and precision, such as how many micrometers are plus or minus 1mm. If there are too many wrong sizes, it will become a waste product. At this time, it is equivalent to re-processing, which is time-consuming and laborious, and sometimes even makes the entire processed material scrapped. This caused an increase in costs, and at the same time, the parts were definitely unusable. The processing of Precision parts is mainly dimensional requirements. For example, what is the diameter of the cylinder, there are strict requirements, and the positive and negative errors are within the specified requirements are qualified parts, otherwise they are unqualified parts; length, width and height also have specific strict requirements , The positive and negative errors are also specified, such as an inline cylinder (take the simplest basic parts as an example), if the diameter is too large and exceeds the allowable range of the error, it will cause a situation where it cannot be inserted, if the actual diameter If it is too small, it will exceed the lower limit of the allowable negative value of the error, which will cause the insertion to be too loose and the problem of infirmity will occur. These are unqualified products, or the length of the cylinder is too long or too short, which exceeds the allowable range of the error. They are all unqualified products. They must be scrapped or reprocessed, which will inevitably cause increased costs. The above are the requirements for Precision parts processing, which is the most important size problem. It must be processed in strict accordance with the additional drawings. The actual size of the processing will definitely not be the same as the theoretical size of the drawing, but as long as the processing size is within the tolerance Qualified parts are within the scope, so the requirement of Precision parts processing is to strictly follow the theoretical size. Its Times is advanced Precision parts processing equipment and testing equipment. Advanced processing equipment makes it easier to process Precision parts, with higher precision and better results. The testing equipment can detect the parts that do not meet the requirements, so that all products sent to customers can truly meet the requirements.
